Expanded Table for Boost
Posted: Thu May 03, 2012 8:17 pm
Hello Hondata,
I am opening the calibration for expanded boost. I was thinking that the tables would run up on the psi. however it stops at .2 psi. if i am doing this wrong could someone explain it. please. here is where i am now. k20z3 t4 a/r .50 turbo on a cast manifold with a 2.5 inch downpipe to a 2.5 exhaust. have a skunk2 intake manifold, P2R fuel rail, and RDX 410cc injectors, 38mm wastegate with a 8 psi spring. front mount intercooler, hks ssqv bov, and a mac soleniod. so i was able to start the car on the pre calibration for the rdx injectors thats how it is at the moment and havent driving want to get this right first. so i was trying to figure out how to expland the tables to account for boost.
Thanks again,
Tshay
P.S. i am new to this however want to learn.
I am opening the calibration for expanded boost. I was thinking that the tables would run up on the psi. however it stops at .2 psi. if i am doing this wrong could someone explain it. please. here is where i am now. k20z3 t4 a/r .50 turbo on a cast manifold with a 2.5 inch downpipe to a 2.5 exhaust. have a skunk2 intake manifold, P2R fuel rail, and RDX 410cc injectors, 38mm wastegate with a 8 psi spring. front mount intercooler, hks ssqv bov, and a mac soleniod. so i was able to start the car on the pre calibration for the rdx injectors thats how it is at the moment and havent driving want to get this right first. so i was trying to figure out how to expland the tables to account for boost.
Thanks again,
Tshay
P.S. i am new to this however want to learn.