Page 1 of 1

connecting to ECU

Posted: Mon Aug 18, 2008 11:17 am
by 315Customs
I need to burn a basemap since I just install my JRSC with 575cc injectors. Do I connect to my ecu from laptop through the datalogging port on my blue interface box. I have a s200

Posted: Mon Aug 18, 2008 11:41 am
by Spunkster
Have you purchased Romeditor 4? Do you have a programmer?

Posted: Mon Aug 18, 2008 11:55 am
by 315Customs
I downloaded what I thought I had needed from the website. ROM Editor 4 for the software section and I thought I could put a basemap in with just that, my laptop and a cable.

Posted: Mon Aug 18, 2008 2:35 pm
by Spunkster
No, to use the software you must purchase it, a programmer and an emulator. If you wish to tune you should just upgrade to an s300 as it will be cheaper and easier than upgrading the proper software and hardware to tune with the s200.