Hondata

I just got the boost option and 3 step enabled a few days ago.
I started a fresh map, added boost tables, etc and i get a boost cut at 1psi with a quick cel blink.
I set boost cut to 0kpa and shut off boost cut if check engine light, for testing and i still get the boost cut.
Crome works fine...

Any suggestions?

What is the serial number of the s200?

s200-3250 (Came with Datalogging)
Romeditor 4# #0270 (Purchased with Boost and 3 Step)

I havnt had a problem with any NA cars as of yet, and generally for boost i suggest customers purchase an s300 from me so i just noticed this going on recently.

I wish s100 had injector dead times, but id asume that wont be an option since s200 is obsolete, but either way im not sure whats causing this issue.

And i am a Hondata Dealer.

You will need to post your calibration as well as a datalog showing the problem.