Page 1 of 1
Posted: Tue Aug 31, 2010 12:50 pm
i have hooked up everything and i ready to tune. i opened screen up and click to datalogging it shows most of the sensor except AF. AF not reading right. leave on lamda it shows 0, change to afr it shows 10.0:1. step on the gas pedal it starts moving but it stopped.
woul you help me please
Posted: Tue Aug 31, 2010 1:00 pm
What wideband are you using and how do you have it connected?
Posted: Tue Aug 31, 2010 1:08 pm
i am using innovate LM1 wideband, power hooked on, serial port hooked on, wideband sensor hooked on, i hooked analog output to d14 on computer side and ground
Posted: Wed Sep 01, 2010 9:37 am
Posted: Wed Sep 01, 2010 12:33 pm
yes everything is plugging, analog out (there are 3 wires, ground, red, white). i plug white wire to d10, red wire to d14, black wire to ground. like i said it was reading but its not reading right, i stumped on the gas pedal it shown 10.0 but it shown 14.5 on lamda overlay at idle.
Posted: Fri Sep 03, 2010 11:58 pm
0-10 and 5-20 at lamda overlay, so everything works normally