Page 1 of 1
Stock EK9 b16b Basemap
Posted: Mon Jan 19, 2009 11:00 am
I need something to start with on my stock EK9.
All it has is a Mugen 4-1 Header. So farely stock.
Can anyone help? Or should i start with the ITR stock, or stock P30 B16A map?
Posted: Tue Jan 27, 2009 2:39 pm
start with ITR and go from there id say.
Posted: Wed Jan 28, 2009 9:28 am
Is their not so much difference between these two?
Posted: Wed Feb 04, 2009 6:33 pm
load the ITRmap on , do a datalog watching your A/F doesnt get too lean, and post up a datalog.
Posted: Sun Feb 08, 2009 6:50 am
I'm waiting for my Wideband to arrive. My stock Lambda is broken.
When i have it i'll post it. Thanks in advance!!
Posted: Sun Feb 08, 2009 12:13 pm
Open loop tune for a tarmac rally car.
Shame the attachments have been lost, as the dyno graph showed stock factory EK9 ECU V Hondata - and some impressive gains midrange.
I'll post the revised tune later in the month - the engine is being rebuilt this week with Skunk Pro2 cams and a Hytech header, and a few minor tweeks. Due to be tuned Feb 21st.
Posted: Sun Apr 19, 2009 11:58 am
Here is the Datalog I did today with my newly PLX wideband installed.
There are some problems with idle, sometimes it drops down and the engine stalls.
But this can be because of the stock ITR map i've used. I altered some setting for the installation of my PLX wideband.
Can someone please have a look at my datalog :oops:
Posted: Sun Apr 26, 2009 11:05 am