Hello all,
Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams
We are having problems tuning out the whole that has appeared when it changes from Low to High cam
Tried:
Moving v-tec change point
Changing back to 60mm CTR throttle body
Can anyone assist or even supply a calibration that may help?
Thanks
Brent
S300 calibration for JUN III cams
No, its an EG4 with EK9 running gear basically.OTT wrote:You got this in an EK9 then?
what wideband are you useing?
I'm sure I can help
Not sure what you mean by wideband, do you mean oxy sensor?
The guy that does my tuning suggested I post something on here to try & find some help.
Any help is appreciated.
thanks
Brent
Re: S300 calibration for JUN III cams
how did u go with the tune for the above set up? could u post the map for it?B16B wrote:Hello all,
Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams