I am new to Hondata. I did watch a few videos to help me get started, but I do have a couple of questions. One why the read-option isn't available on the tps part of calibration? two I have a bigger throttle body in this do I have to adjust for it or would it adjust after reading it?
I used a stock b20 base calibration just to get it running because that's the engine I have in this car everything engine and trans is stock except the throttle body.
thanks in advance
Throttle body adjustment/ help?
Re: Throttle body adjustment/ help?
You can calibrate it when you have the calibration open, and you datalog. It will allow you to read open and closed. Reupload to the ECU, Make sure you save a cop of your calibration to the hard drive.
Re: Throttle body adjustment/ help?
Thank you ill have to try it when i get my car back from the shop next week.
let you know if i have any success.
let you know if i have any success.
Re: Throttle body adjustment/ help?
FINALLY got a chance to start this again, now i have new problem it doesn't seem like the software is reading the sensors or anything, i cant even see rpm with it. i tried data logging but its just straight lines nothing is changing even when i revved it a little to get things to change... so lost, any help appreciated
Re: Throttle body adjustment/ help?
Who socketed the ECU?
Is J12 cut inside the ECU?
From Help, About, what is the version of software you are using?
Is J12 cut inside the ECU?
From Help, About, what is the version of software you are using?