Need help with my basemap!!

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Posts: 1
Joined: Fri Dec 22, 2017 8:44 pm

Need help with my basemap!!

Post by Eh9ev »

B20b low compression stock block
Stock fpr
RC 440cc Injectors
Skunk2 b16 intake mani
Skunk2 70mm throttle body
Stock Fuel filter
Plm Headers
AEM high volume fuel rail
Blox 2.5 in
Walbro 255 fuel pump
Aem wideband a/f
Oil pressure gauge

Type R head
Type R cams
Super tech springs
Super tech retainers
OEM valves
OEM valve seals
ARP headstuds
Slight port & polish

I loaded the preloaded basemap off s300 but I'm still running rich. Any help would be appreciated !

G. Wiffington
Posts: 43
Joined: Tue Nov 21, 2017 12:24 pm

Re: Need help with my basemap!!

Post by G. Wiffington »

Have you wired your Wideband to the ECU itself? If not try that so that way you can actually see on Smanager where fuel can be taken away. The option "Fuel Change" can help you identify in what cells are very rich, if not the entire map. It will show you how rich/lean every cell is by percentage.
Hope this helps out.

Post Reply