Page 1 of 1
Need help if possible with d16z6
Posted: Tue Jul 25, 2017 10:51 am
by Lownslow03
Hey guys. I recently just installed the s300 with couple of mods on to my d16z6 and need help on some settings for it to idle normal...I installed a ported skunk2 intake manifold with some rc 750 injectors and an aem 340 fuel pump...I got dead times off the injectorfab website as well...I been trying couple things and nothing.. trying to get a good idle and maybe a driveable baseman to get to local tuner. Any advice will help thanks
Re: Need help if possible with d16z6
Posted: Tue Jul 25, 2017 11:04 am
by Spunkster
Do you have a wideband so that you can see the AF ratio?
Re: Need help if possible with d16z6
Posted: Tue Jul 25, 2017 11:10 am
by Lownslow03
Yes it's hooked up to pin d10..on start up its reading 14.6... but its reved up to like 3500..then aaround 20 sec later the idle starts surging from 1000 to 3000 with afr going from 18.2 to like 13.4 I think
Re: Need help if possible with d16z6
Posted: Tue Jul 25, 2017 11:57 am
by Spunkster
Start by calibrating the TPS, and then make sure there are no air leaks.
Re: Need help if possible with d16z6
Posted: Mon Aug 14, 2017 5:39 pm
by Lownslow03
Sorry for no response for a while..but got the idle issue fixed. It was my throttle body was to small for my intake manifold( ported skunk 2 for 70mm to to a stock d16 to)