Basemap b16a skunk2 pro 2 cams needed

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Posts: 4
Joined: Thu Mar 16, 2017 10:57 am

Basemap b16a skunk2 pro 2 cams needed

Post by Sebounet »

Hello everybody,

Here my configuration:
- Skunk2 stage 2 pro series cams
- Skunk2 cam gears
- Skunk2 pro series valve retainers and springs
- 4-2-1 stainless steel header
- RC SL9-310cc injectors
- Hondata S300v3 in P30-G00 ECU with harness
- AEM wideband sensor 30-4110
- OBD1 ignition distributor with harness

If anyone hat a basemap for this configuration or a similar one I'll take it as inspiration. I'm a Mecatronics but this is the first time that I'm remapping an engine.

Thank you in advance.

- honda Knock sensor would be ordered.
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: Basemap b16a skunk2 pro 2 cams needed

Post by Zperformance »

I set idle at 1k to hold the idle with the bigger cam. Adjust AFR to spec. Let me know how it works and if there is any problem i will help as much as i can.
B16 cam.skl
*I will not be responsible for any damage*
(45.49 KiB) Downloaded 152 times
Post Reply