B18C N/A Basemap

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Kraztec
Posts: 5
Joined: Sat Dec 17, 2016 10:28 am

B18C N/A Basemap

Post by Kraztec » Sat Dec 17, 2016 10:31 am

I've recently bought a shell w/ s300 and I'm swapping my B18C w/ Edelbrock Victor X, 68MM TB and full exhaust system over. Stock map stock injectors, 255lph fuel pump all that fun stuff... Anyone have a basemap for a similar setup that I can load to get the car to my tuner?

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B18C N/A Basemap

Post by Zperformance » Sun Jan 15, 2017 11:05 am

Stock b18c map should be capable to run the car. Get a afr hook up and adjust the afr

keto06
Posts: 499
Joined: Fri Jul 17, 2009 9:29 pm

Re: B18C N/A Basemap

Post by keto06 » Wed Jan 25, 2017 9:18 pm

07 Civic Si Sedan
Drop-In Filter, Berk HiFlow Cat, 2.5" exhaust, 60a rear mount, Mugen Sport Suspension, FlashPro Tuned by me.
14.6@97 (full weight)
Hit me up for free Hondata Help!

nuclearyouth
Posts: 1
Joined: Thu Jun 22, 2017 7:51 pm

Re: B18C N/A Basemap

Post by nuclearyouth » Thu Jun 22, 2017 8:02 pm

Hey im using the basemap of a gsr for my gsr. However I'm getting a ten afr when driving and a 13.3 afr at idle. also i cant figure out how to turn the cel off and disable the 02 sensor.

ajmatthews88
Posts: 2
Joined: Mon Jun 12, 2017 5:16 pm

Re: B18C N/A Basemap

Post by ajmatthews88 » Sun Jun 25, 2017 9:54 am

Zperformance wrote:
Sun Jan 15, 2017 11:05 am
Stock b18c map should be capable to run the car. Get a afr hook up and adjust the afr
I am getting a code P0123 Throttle pedal position sensor switch a high circuit high input . (not using this tune ,using a different tune you put out zperformance ) So my question is how do you adjust the afr setting ?

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B18C N/A Basemap

Post by Zperformance » Sun Jun 25, 2017 6:49 pm

nuclearyouth wrote:
Thu Jun 22, 2017 8:02 pm
Hey im using the basemap of a gsr for my gsr. However I'm getting a ten afr when driving and a 13.3 afr at idle. also i cant figure out how to turn the cel off and disable the 02 sensor.
you will need to lean out your fuel map for the tune. If you are not comfortable, you should take it and get it tuned professionally

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B18C N/A Basemap

Post by Zperformance » Sun Jun 25, 2017 6:50 pm

ajmatthews88 wrote:
Sun Jun 25, 2017 9:54 am
Zperformance wrote:
Sun Jan 15, 2017 11:05 am
Stock b18c map should be capable to run the car. Get a afr hook up and adjust the afr
I am getting a code P0123 Throttle pedal position sensor switch a high circuit high input . (not using this tune ,using a different tune you put out zperformance ) So my question is how do you adjust the afr setting ?
you have to set your TPS sensor. If you are not sure about it you should take it to get tuned professionally.

kingcdk87
Posts: 1
Joined: Wed Jul 26, 2017 6:02 pm

Re: B18C N/A Basemap

Post by kingcdk87 » Wed Jul 26, 2017 6:11 pm

I am having an issue passing emissions with my stock B18C GSR swap. I am using the S300 USDM P72 Base Map Tune and have high HC and CO readings according to emissions reps. Do I need to get this car tuned professionally to pass emissions, or should this base map be plenty? My sensors are all operating as designed to my knowledge. Getting poor gas mileage and can smell fuel, but car runs great. Any thoughts ? I have no CEL or anything.

Kraztec
Posts: 5
Joined: Sat Dec 17, 2016 10:28 am

Re: B18C N/A Basemap

Post by Kraztec » Thu Jun 21, 2018 12:19 pm

The came and skunk 2 are what I'm missing. I got a basemap from from John Kerr/jktuning but the afr seems to bounce all over and drop to 10 at wot still. Mid 13-low 14 on cruise.

Kraztec
Posts: 5
Joined: Sat Dec 17, 2016 10:28 am

Re: B18C N/A Basemap

Post by Kraztec » Thu Jun 21, 2018 12:20 pm

Zperformance wrote:
Sun Jan 15, 2017 11:05 am
Stock b18c map should be capable to run the car. Get a afr hook up and adjust the afr
Not too familiar with adjusting afrs so I don't wanna toy with those, unless you have tips. I don't wanna destroy 3000 lol

Kraztec
Posts: 5
Joined: Sat Dec 17, 2016 10:28 am

Re: B18C N/A Basemap

Post by Kraztec » Thu Jun 21, 2018 12:33 pm

kingcdk87 wrote:
Wed Jul 26, 2017 6:11 pm
I am having an issue passing emissions with my stock B18C GSR swap. I am using the S300 USDM P72 Base Map Tune and have high HC and CO readings according to emissions reps. Do I need to get this car tuned professionally to pass emissions, or should this base map be plenty? My sensors are all operating as designed to my knowledge. Getting poor gas mileage and can smell fuel, but car runs great. Any thoughts ? I have no CEL or anything.
I'd recommend a tuners fine tune on it really. If you're not running the right afrs you'll be hit with those

Post Reply