B16A2 semi allmotor build map needed

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Sneaky_84
Posts: 7
Joined: Wed Oct 19, 2016 5:48 pm

B16A2 semi allmotor build map needed

Post by Sneaky_84 » Thu Oct 20, 2016 1:47 pm

B16a 2nd gen Engine:
-Skunk2 camshaft tuner stage 2
-skunk2 camgear
-skunk2 pro intake manifold
-skunk2 titanium retainers
-skunk2 valve spring
-CTR Piston w/ new rings
-ACL main&rod bearings
-ARP head stud&rod bolts
-blueprinted block
-OBX throttle body
-ITR airbox with air duct to bumper, k&n filter
-toda replica stainless steel header
-ITR helical lsd
-9lb flywheel
-stage 1 excedy clutch kit
-RC 330cc injector

need a basmap asap, thanks.....

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B16A2 semi allmotor build map needed

Post by Zperformance » Sun Oct 23, 2016 7:08 pm

Adjust AFR to spec. Let me know how it does this is a descent basemap to get you up and running. Let me know how it do!
Attachments
B16 built basemap.skl
*Use at your own risk*
(45.75 KiB) Downloaded 231 times

Sneaky_84
Posts: 7
Joined: Wed Oct 19, 2016 5:48 pm

Re: B16A2 semi allmotor build map needed

Post by Sneaky_84 » Fri Oct 28, 2016 12:30 pm

i install your map, the start up is good. only feel like misfire at idle, maybe because i didn't degree the cams yet.
tomorow i'm goining to let the cams be degreed, will try it again.

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B16A2 semi allmotor build map needed

Post by Zperformance » Fri Oct 28, 2016 8:02 pm

Do you have a wideband?

Check your distributor timing.

Sneaky_84
Posts: 7
Joined: Wed Oct 19, 2016 5:48 pm

Re: B16A2 semi allmotor build map needed

Post by Sneaky_84 » Sat Oct 29, 2016 4:05 pm

No i dont have a wideband yet.
And the old owner had the dizzy full advanced.

But tomorow i'm going to the dyno.

Sneaky_84
Posts: 7
Joined: Wed Oct 19, 2016 5:48 pm

Re: B16A2 semi allmotor build map needed

Post by Sneaky_84 » Thu Nov 03, 2016 1:43 pm

thanks, the car is running great now..

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: B16A2 semi allmotor build map needed

Post by Zperformance » Thu Nov 03, 2016 6:43 pm

That is great to hear! What are your #'s?

Post Reply