Hondata

i just built an lsvtec and am in the process of installing it. but i have yet to find a calibration that has been confirmed to work. i just need a basic tune so i can break in the motor. or is it possible to just use one for a b18c1?

my engine is a b18a block with pr3 pistions and pr3 head. my compression is around 11.6/1

please help!

BUMP!

No response even fron spunkster?
i have searched the vault and could not find any setups close to mine

Have you tried the ls/vtec base calibration built into the software in the new calibration window?

Is there one? The closest one i saw was the itb.skl and it says its setup for itb's and 440 injectors. I'm only running stock 240 injectors and am waiting for RC310's in the mail. I will recheck when I get home though. If you say there is one then there must be.

P.S. thanks for replying

What calibration did you end up using and it may seem dumb. But after I put the new injector size to 440 how do I save that to the ecu? As in steps for where the key needs to be. Then what to select on the program?

Should be startup. Adjust AFR to spec. Let me know how it do, i will try to help as much as i can.






*Use at your own risk I will not be responsible for any problem or damage to your engine*