Page 1 of 1

D16

Posted: Sat Oct 11, 2014 4:58 pm
by gnxpro24
I need a basemap for a stock d16y8 Hondata s300. Anyone?

Re: D16

Posted: Mon Oct 27, 2014 7:52 am
by hpmx18
gnxpro24 wrote:I need a basemap for a stock d16y8 Hondata s300. Anyone?
use the d16a1 and make changes till your able to idle the car and go from where if you have a wideband

Re: D16

Posted: Fri Oct 31, 2014 7:02 pm
by Monnoracing
The p28 map should run the car with no changes needed.

Re: D16y8

Posted: Sun Feb 19, 2017 9:19 pm
by keveneleven
hpmx18 wrote:
gnxpro24 wrote:I need a basemap for a stock d16y8 Hondata s300. Anyone?
use the d16a1 and make changes till your able to idle the car and go from where if you have a wideband
Don't do that. The D16A1 is a DOHC non vtec engine. The base map for it will not work on a SOHC vtec engine. You need to used the preloaded base map for the 92-95 P28. That is the base map for the D16z6, but if you knock 4-5 degrees of timing out of it, hook up a wideband if you don't have the s300 v3 and dial in the fuel mapping. That will get you in the general area. It will be running a bit rich at that point, but it won't damage anything like too much timing or running too lean can do. I will post my D16y8 base maps next time I am at home.

Re: D16y8

Posted: Wed Apr 26, 2017 7:19 pm
by keveneleven
Thanks for the replys. I appreciate all of them. So here is the deal. I have a fresh d16y8 with a semi built bottom end and fully built head that I am just breaking in. I will be boosting it very soon so I was hoping to find someone that has a good quality tune for the engine while it is still N/A. I don't want to spend the 300-400$ to get it tuned just to turn around and do the same thing in a few weeks once it gets some boost.