s100 safe mode?
s100 safe mode?
recently my wiring in my car was chewed up by a rabbit. i fixed all the wiring problems but now my car wont rev past 3500 rpm. i was wondering if maybe my computer has become deprogrammed, or perhaps its in safe mode? any ideas?
does a s100 equipped ECU allow for the reg. CEL checking process of jumping the 2 pin connector by the ECU?
I am trying to trouble shoot, mine, but the CEL only stay solid when the plug is jumped. (i think the ECU is not quite right.)
also I noticed a solid red light on the s100 board. is that normal?
I am trying to trouble shoot, mine, but the CEL only stay solid when the plug is jumped. (i think the ECU is not quite right.)
also I noticed a solid red light on the s100 board. is that normal?
SOHC guy
romeditor v4.
the map he started from has started every car he's tuned. We played with the fuel trim up and down at startup but didn't seem to make a difference.
What if there are no codes? is it standard for the light to come on and stay on?
I have a vitara/eagle setup. would my low CR make it an issue?
the map he started from has started every car he's tuned. We played with the fuel trim up and down at startup but didn't seem to make a difference.
What if there are no codes? is it standard for the light to come on and stay on?
I have a vitara/eagle setup. would my low CR make it an issue?
SOHC guy
There is a known bug in Romeditor 4 that does not allow the SCS input to flash the CEL with error codes. This will be resolved in a future release. For now you will have to datalog the error using Romeditor 4.
Last edited by Spunkster on Tue Apr 14, 2009 9:15 am, edited 1 time in total.