B16b Hondata S200 CEL ON
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
spunkster, in the software for the s200 there is no setting to set a shift light, when datalogged there is no error codes that come up in hondalogger so all sensors are workign fine and car runs fine. i have tried burnign a new rom onto a new chip and installed. the light also remains on while romulator is connected. i will try using a base map to load on the car and see if the tuned file has a corrupted sector in it or something unless you have seen this before to make some suggestions
spunkster is you have an email i can send you the file and you can have a lookie over it for this setting of shiftlight as i cant seem to find it on my version of software.
spunkster is you have an email i can send you the file and you can have a lookie over it for this setting of shiftlight as i cant seem to find it on my version of software.
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
i have attached the bin file but zero'd all the tables but all the other settings are the same as the rom in the car.
- Attachments
-
- lee blank tables.bin
- blank tables
- (32 KiB) Downloaded 159 times
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
ok i have replaced the ecu with a seal totally un molested p28 ecu new chip new wiring new everything except the s200 itself. i then used my own dealer s200 to set up the car to pass an emmisions test and walla the engine light went out with no eror codes showing.
once i stuck in the customers original s200 after burning the rom the engine light comes on after start up but no error codes stored hhhmmm put back my dealer s200 and presto the engine light doenst come on , put in the customers s200 and it comes on so i traced it to a faulty s200 by the looks of it.
once i stuck in the customers original s200 after burning the rom the engine light comes on after start up but no error codes stored hhhmmm put back my dealer s200 and presto the engine light doenst come on , put in the customers s200 and it comes on so i traced it to a faulty s200 by the looks of it.
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact:
-
- Posts: 25
- Joined: Sat May 20, 2006 4:24 am
- Location: aberdeenshire
- Contact: