Okay, i have a stock b16A2 with 750cc injectors and 3 bar map. They are saturated. I got a basemap for all this.. so he said, i put it in (u notch facing the harness) and attempted to start it. It wouldnt run at all. The red light was flashing in the blue box, and my CEL was on.
I put back in stock ECU, it started but was very crappy cause of the injectors. What do you think the problem could be? Maybe he didnt disable knock?
When i put in this new chip that got burned tomorrow and it sitll doesnt start what then??
Is it possible i have a bad P28? i mean, the connection to the blue box obivously works cause the red light is telling me something.
Car wont start after Turbo install/hondata
The interface box LED is flashing slowly
The problem lies with the Hondata interface box not being able to communicate with the ECU. Possible causes for this problem:
? Incorrect ROM used for the ECU.
? ROM inserted the wrong way around.
This is from the S200 installation manual
http://hondata.com/downloads/s200%20ins ... manual.doc
The problem lies with the Hondata interface box not being able to communicate with the ECU. Possible causes for this problem:
? Incorrect ROM used for the ECU.
? ROM inserted the wrong way around.
This is from the S200 installation manual
http://hondata.com/downloads/s200%20ins ... manual.doc