dumping fuel, weird map readings
Posted: Tue Apr 13, 2004 4:52 pm
So, I just got my car together, and after uploading the map to my romulator, I start up the car. It is DUMPING fuel like mad.
Here's the basics of the setup
d16z6
t3 turbo (waste gate left open for braking in the engine)
s200B
3 bar map (wired per hondata instructions)
dsm 450cc with honda resistor box
So, the map sensor is reading at about 27 psi as soon as I turn the engine over, and stays pegged. I'm guessing that's why it's dumping fuel. To even make it idle, I had to set my injector multiplier at 0.09. If I disconnect the map sensor, it still reads voltage. If I disconnect the tps, it still shows up on the hondalogger. Neither was throwing a CEL last night, and now it just throws a code whenever I try to start it, but it doesn't show a code in hondalogger, nor can I use the jumper to pull a code. I'm stumped on the map sensor readings, and why it's dumping fuel like mad.... HELP THE NOOB!
Here's the basics of the setup
d16z6
t3 turbo (waste gate left open for braking in the engine)
s200B
3 bar map (wired per hondata instructions)
dsm 450cc with honda resistor box
So, the map sensor is reading at about 27 psi as soon as I turn the engine over, and stays pegged. I'm guessing that's why it's dumping fuel. To even make it idle, I had to set my injector multiplier at 0.09. If I disconnect the map sensor, it still reads voltage. If I disconnect the tps, it still shows up on the hondalogger. Neither was throwing a CEL last night, and now it just throws a code whenever I try to start it, but it doesn't show a code in hondalogger, nor can I use the jumper to pull a code. I'm stumped on the map sensor readings, and why it's dumping fuel like mad.... HELP THE NOOB!