s200 CEL

Hondata installation questions / answers / issues.
Post Reply
cleantegra
Posts: 1
Joined: Thu Jun 03, 2010 1:46 pm

s200 CEL

Post by cleantegra »

I went from a stock b16a2 to a b16a built motor with lower compression. Car started immediately once swapped but idles really high. The ECU was tuned on dyno for stock motor. It threw CEL but unable to pull the code. once I connect the 2 pin connector to check code, the CEL turns off. Everything was installed correctly.


Edit: obviously has to be re-tuned, but dont see why a CEl would come up.

Thanks in Advance.
User avatar
Spunkster
Site Admin
Posts: 19266
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster »

Check the error code using the Hondata software. You may have to have the dealer/tuner do this for you.
Post Reply