Page 1 of 1

Knock sensor with S300 ??

Posted: Fri May 01, 2009 9:38 am
by djxphil
Hi, i have a b16a1 withe a P30 Obd1 ECU. I would like to install a knock sensor on my car. Is it possible with an hondata S300 ?

ThanK you.

Posted: Fri May 01, 2009 10:29 am
by Spunkster
As long as there is an extra circuit board (knock board) screwed into the ecu then yes you can use knock control. Be aware that you may have to run the wiring in your vehicle for this.

Posted: Fri May 01, 2009 10:36 am
by djxphil
Thanks for the answer.

How to see if i have the knock board ?. thanks

Posted: Fri May 01, 2009 10:56 am
by Spunkster
look inside the ecu

Posted: Sat May 02, 2009 5:36 am
by Masta_Cutz
Spunkster what's the dealio with swapping the knock sensor in my P13 ecu and moving it into my P72? (if i aint blown the whole thing)

is it a case of moving the tuned microphone or something more complicated?

Posted: Mon May 04, 2009 11:47 am
by Spunkster
You can try that.

Posted: Mon May 04, 2009 12:38 pm
by Muckman
Are there settings for knock control or is it just for logging?

Posted: Mon May 04, 2009 1:00 pm
by Masta_Cutz
I would be using them for knock control but to be able to datalog what it's doing would be even better.

the P72 has a knock sensor, would be a shame not to use it.

Posted: Mon May 04, 2009 1:53 pm
by Spunkster
Knock control is either on or off. Ther are not other settings. It is all internally controlled by the knock board.