Boost selenoid question

bigbadboy · Post by **bigbadboy** » Tue Oct 09, 2007 8:39 pm

ok i have an apexi seleniod. ive been having problems setting the boost up correctly using the s300. now i just want to check that i have it hooked up right. i have 3 ports on my sel. one where it comes in and 2 out. one of the outs is so u can use the sel as normally open and one for normally closed. if i'm using the one thats set up for normally closed and i suppose to plug the port i'm not using or leave it open???

Post by **Spunkster** » Wed Oct 10, 2007 12:28 pm

A boost control solenoid cannot be changed from normally open or normally closed. It is either one or the other. You will have to look at the technical information on the model you have to see how it should be plumbed. There are about 6 different styles of Mac valves.

bigbadboy · Post by **bigbadboy** » Fri Oct 12, 2007 10:47 pm

sorry i dont know if i didn't post it or u didn't read it. its an Apexi seleniod valve and yes it can be routed to be both

Post by **Spunkster** » Mon Oct 15, 2007 9:37 am

Please provide documentaion of this.