Page 1 of 1
smoothing
Posted: Tue Nov 15, 2005 5:37 am
by ridewhencan
I've ten datalogs where I've made the "estimated fuel change" corrections. In a few places, the 2d map looks a little bumpy. Is this a good time to use the smoothing function over the entire map?
Posted: Tue Nov 15, 2005 10:40 am
by Spunkster
without posting the map, it is impossible to say, but the best way is to smooth the lines in the 2D view and do each line separately.
Posted: Tue Nov 15, 2005 1:26 pm
by ridewhencan
Attached is the most recent calibration. I wasn't sure how to post the maps only.
Posted: Tue Nov 15, 2005 2:15 pm
by Spunkster
If the car is NA, then it looks smooth already