Page 2 of 3
Re: air con problem
Posted: Mon Jan 20, 2020 12:49 pm
by Spunkster
The engine is not running in that datalog.
Re: air con problem
Posted: Mon Feb 17, 2020 11:42 am
by haRRibo
sorry for late
can you please look on this?
Re: air con problem
Posted: Mon Feb 17, 2020 12:41 pm
by Spunkster
In this datalog your engine does not appear to be running.
Re: air con problem
Posted: Sun Apr 26, 2020 12:53 pm
by haRRibo
sorry for late
can you please look on this?
Re: air con problem
Posted: Mon Apr 27, 2020 11:21 am
by Spunkster
The ACSW is not showing on, so there may be a problem with your adapter harness you are using.
Re: air con problem
Posted: Tue Apr 28, 2020 1:15 pm
by haRRibo
All pins on the harness are correct for the A/C.
On OBD1 the pin for the A/C relay is A15 and the pin for the A/C switch is B5
On the OBD2a the A/C relay is A17 and the pin for the A/C switch ia C5
I did a double check of all cables and are OK.
But I can buy a new one.
Can you reccomend me any good adapter harness????
Re: air con problem
Posted: Tue Apr 28, 2020 1:29 pm
by Spunkster
What is the part number on your ecu?
Re: air con problem
Posted: Wed Apr 29, 2020 8:32 am
by haRRibo
These numbers are on my ECU:
37820-P30-G00
775-104361 1A14
Re: air con problem
Posted: Wed Apr 29, 2020 11:15 am
by Spunkster
Remove the s300 and cut J1, this will allow the ECU to run as stock. See if it works properly then.
Re: air con problem
Posted: Fri May 01, 2020 2:34 pm
by haRRibo
I removed the s300 and connected the ECU to the car.
The ground signal to the AC clutch disappeared. Looks OK.
But I can't run the car with this ECU without hondata because is from 1,6 engine and I have 2,2 turbo.
Do I have to still cut J1?
Re: air con problem
Posted: Fri May 01, 2020 3:12 pm
by Spunkster
J1 must be reconnected to use the s300.
Re: air con problem
Posted: Mon May 04, 2020 9:33 am
by haRRibo
OK I did it.
The ground signal to the AC clutch disappeared. Looks OK again.
Re: air con problem
Posted: Mon May 11, 2020 1:32 pm
by haRRibo
any advice?
Re: air con problem
Posted: Mon May 11, 2020 2:29 pm
by Spunkster
So it is working correctly with J12 connected?
Re: air con problem
Posted: Sat May 16, 2020 4:38 am
by haRRibo
only J1 is reconnected and looks OK