Page 1 of 1

Unable to set target lambda parameters on version 2.6.9.0

Posted: Wed Apr 03, 2019 8:16 pm
by nickman
Installed latest version today and I noticed I'm unable to set lambda parameters base on engine load. I'm on windows 10
smanager.jpg
smanager.jpg (466.06 KiB) Viewed 1858 times

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Wed Apr 03, 2019 11:39 pm
by Hondata
Fixed in v2.7.0

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 6:03 am
by nickman
Sweet thanks!

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 9:11 am
by nickman
Hondata wrote:
Wed Apr 03, 2019 11:39 pm
Fixed in v2.7.0
Since the update to 2.7 I got a couple of problems.
I am to connect to the ECU and download the basemap. But when I attempt to datalog it gives an error and automatically closes the application.
I also notice that if I don't download the basemap on the ecu it connects to datalog and when I attempt to download the basemap while datalogged it gives the same error
datalog.jpg
datalog.jpg (512.13 KiB) Viewed 1832 times
connected.jpg
connected.jpg (280.58 KiB) Viewed 1832 times
Also this maybe minor but on column 10 on the fuel map no matter if I change it to vacuum or psi its value is not right.
column.jpg
column.jpg (507.92 KiB) Viewed 1832 times

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 9:21 am
by Hondata
What s300 do you have, and what are you doing then you 'download the basemap'?

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 9:38 am
by Hondata
Ok, I've got it. You need to go into settings and set the datalog overlay sensor to something. I think the lambda sensor might still be a problem for you (if it does not say 'AF'), but I'll make a new release shortly that will take care of it.

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 10:07 am
by nickman
Hondata wrote:
Thu Apr 04, 2019 9:21 am
What s300 do you have, and what are you doing then you 'download the basemap'?
I am running S300 V3. I go under the "online" tab and click download when I'm connected to my ECU to download the current tune.
download.jpg
download.jpg (272.99 KiB) Viewed 1829 times

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 10:13 am
by nickman
On version 2.6.8 I didn't have this problem

Re: Unable to set target lambda parameters on version 2.6.9.0

Posted: Thu Apr 04, 2019 12:09 pm
by Hondata
Try 2.7.1