S300 v3 and Aem uego
Posted: Sun Feb 03, 2019 9:49 am
Hi hopefully I’ve posted this in the right section
So I’ve finally installed my s300v3 p28 I’ve had my wideband running for a few months and it’s been reading correctly but as soon as I swapped from my stock p28 into the Hondata p28 the readings on the gauge itself have gone well out of spec
I later pinned it’s white 0-5 volt wire into d14 and on the live data it’s showing a afr of 18 but the gauge itself is reading 11, if I return the stock ecu back into the car it returns a reading of 15 on the gauge, I’ve tapped the power and the earth for the wideband off the ecu’s power and earth for reference
I’ve spend about 4 hours looking for answers but not found much of any use so I was wondering if anyone else has had a similar issue?
So I’ve finally installed my s300v3 p28 I’ve had my wideband running for a few months and it’s been reading correctly but as soon as I swapped from my stock p28 into the Hondata p28 the readings on the gauge itself have gone well out of spec
I later pinned it’s white 0-5 volt wire into d14 and on the live data it’s showing a afr of 18 but the gauge itself is reading 11, if I return the stock ecu back into the car it returns a reading of 15 on the gauge, I’ve tapped the power and the earth for the wideband off the ecu’s power and earth for reference
I’ve spend about 4 hours looking for answers but not found much of any use so I was wondering if anyone else has had a similar issue?