Low/high load ect fuel comp
Re: Low/high load ect fuel comp
Sorry I was referring to the ecu. I got another ecu from Hamotorsports and it does the same thing. So it's definitely got to be the s300 board. I was wondering how I can get a replacement since mine is defective?
Re: Low/high load ect fuel comp
Post your calibration as well as datalogs showing the issues between the 2 ecus.
Re: Low/high load ect fuel comp
Ok I'll post my calibration and datalog in the morning. I can post the calibration we used for my tuners ecu and s300 but I didn't get a datalog. Nothing abnormal shows up on datalog when the car misses or cuts out. When we hooked up my tuners ecu/s300 we uploaded my calibration and it was really lean everywhere. But once we added fuel it ran good and didn't hesitate/miss.
Re: Low/high load ect fuel comp
Im having issues sharing as zip how else could i share?
- Attachments
-
- 10-25-19 datalog.zip
- (211.52 KiB) Downloaded 101 times
Re: Low/high load ect fuel comp
here is calibration
- Attachments
-
- 10-25-19.zip
- (12.13 KiB) Downloaded 93 times
Re: Low/high load ect fuel comp
What is the serial number that is on the s300?
Re: Low/high load ect fuel comp
Sorry I'll post all the info in the morning I'm at work. Thanks
Re: Low/high load ect fuel comp
Not sure witch one is serial number
44949 or IIIr16
44949 or IIIr16
Re: Low/high load ect fuel comp
H22a4
11.1
Skunk2 pro1 cams
70mmtb ported IM/head
Fic 525cc injectors
H,I,e
Hamotorsports s300 ready ecu
Open lop tune
Replaced all sensors , injectors, injector pigtails, conversion harness, sensor pigtails, IM, all grounds, distributor, coil, plugs, plug wires, battery, checked alternator, compression 225 all 4 cylinders, leak down 5% on COLD engine lol ive checked everything. Replaced axles clutch nothing helped
11.1
Skunk2 pro1 cams
70mmtb ported IM/head
Fic 525cc injectors
H,I,e
Hamotorsports s300 ready ecu
Open lop tune
Replaced all sensors , injectors, injector pigtails, conversion harness, sensor pigtails, IM, all grounds, distributor, coil, plugs, plug wires, battery, checked alternator, compression 225 all 4 cylinders, leak down 5% on COLD engine lol ive checked everything. Replaced axles clutch nothing helped
Re: Low/high load ect fuel comp
Ran good on crome but went to s300 and had lil hiccup at cruise but it's got real bad now.
Re: Low/high load ect fuel comp
Post back to back datalogs showing the differences you are describing.
Re: Low/high load ect fuel comp
My tuner has been out of town so I've been unable to get a datalog with his s300. However I took my ecu cover off and went for a drive and noticed the RED light is flashing. I've changed ecu and conversion harness and checked harness for continuity and it's good. I'm pretty certain the s300 is the issue
Re: Low/high load ect fuel comp
Do you have on-board datalogging enabled in the calibration?
Re: Low/high load ect fuel comp
No it's not enabled
Re: Low/high load ect fuel comp
Send an email to support<at>hondata.com with the following and I will issue an RMA and give you further
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Include a link to this thread
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Include a link to this thread