S300v3 Will Not Rev past 2500 RPMs
Re: S300v3 Will Not Rev past 2500 RPMs
Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Re: S300v3 Will Not Rev past 2500 RPMs
OK, I just emailed that info.
Re: S300v3 Will Not Rev past 2500 RPMs
Not sure why I never got back to this post. The car has been down for a while, but I am still having the same issue. The serial number for the s300 board I believe is 35764. That is the number on the sticker that says S300.
Re: S300v3 Will Not Rev past 2500 RPMs
Never mind, looks like I did get back to this. I do recall sending the S300 board in, but I don't remember if it fixed this issue at the time. Anyways, I'm still having the same issue. I'll have to look at some paperwork to see if you guys had to do anything with the board, or maybe you guys have that on file. Looking at my emails, the RMA# was 4884.
Re: S300v3 Will Not Rev past 2500 RPMs
OK, found my paperwork - Invoice# 59150. Says "RESOLUTION: Corrupted Calibration Tested on bench and car." So how do I fix this??
Re: S300v3 Will Not Rev past 2500 RPMs
Load a new calibration as you may have a corrupt calibration uploaded to the ECU.
Re: S300v3 Will Not Rev past 2500 RPMs
Does that mean I have to completely retune the car?
Re: S300v3 Will Not Rev past 2500 RPMs
If you do not have a backup of the calibration stored on your laptop, then you may have to retune.