Page 1 of 1

Problem putting into gear after upgrading to 2.6.6

Posted: Fri Jul 20, 2018 11:04 am
by codenamezero
Hello,

Been running my Integra fine for 2 years using S300 v2.5.3
This morning I decided to update the software this morning, loaded the old calibration file from 2 years ago.
"Seems" ok and uploaded it to my ECU.

But as soon as I put it in reverse (to get out of my garage, or in gears) and try to give it gas, it dies.

Any quick "check list" or "major change" that I need to verify when going from 2.5.3 to the latest v2.6.6???


Edit: Also, why is Disable Knock Sensor checked by default?

Re: Problem putting into gear after upgrading to 2.6.6

Posted: Fri Jul 20, 2018 12:07 pm
by Spunkster
Without your calibration and a datalog showing the issue it is hard to say what it might be?

What is the serial number on the s200 inside the ECU?