Good Afternoon
I have a H22 EJ9 and iam wondering how I can get fuel and oil pressure feedback on the s300.
Kind Regards
Chris
S300 Fuel and oil pressure
Re: S300 Fuel and oil pressure
replied via email
Re: S300 Fuel and oil pressure
Is this possible? why over email only? :O hehehe
Re: S300 Fuel and oil pressure
I answered myself already sorry for the quick/dumb post, please delete if possible to keep thread clean.
Re: S300 Fuel and oil pressure
From my online research it seems that this can be achieved via either the analogue or digital interface on the s300v3.
Analogue
viewtopic.php?t=9405
Digital
https://honda-tech.com/forums/engine-ma ... k-3203138/
So..... Any advise on which path to take.........
Analogue
viewtopic.php?t=9405
Digital
https://honda-tech.com/forums/engine-ma ... k-3203138/
So..... Any advise on which path to take.........
Re: S300 Fuel and oil pressure
Analog would probably be cheaper and easier.
Re: S300 Fuel and oil pressure
So I have my 2 analogue pressure sensors for fuel and oil which im going to run into A0 and A1 of the s300 and take the +5V and GND from the TPS or MAP sensor supplies to power the senders.
Do I need todo any mods to the ECU for this to work i.e. resistors/capacitors/jumpers
Thanks in advance
Do I need todo any mods to the ECU for this to work i.e. resistors/capacitors/jumpers
Thanks in advance
Re: S300 Fuel and oil pressure
No you do not.
Re: S300 Fuel and oil pressure
I have been trying to run the analogue sensors into the s300 but with no luck.
I have tried inputting a 1.5V reference voltage from a small battery.
The analogue gnd was connected to the 0v of the 1.5V battery.
I have set the conversion to raw data and tried inputting on Analog 0,1 and 2.