Hey I have a P75 ecu with the 1980 board in my LS Vtec turbo crx.
I ordered the vtec conversion components and had them soldered in. The only part I am unsure about is where I will wire the vtec solenoid and oil switch into. Will I just use the P28 locations? Thanks!
A4 vtec solenoid
D6 oil pressure switch
Vtec conversion
Re: Vtec conversion
And I noticed for the vtec conversion instructions there are a couple versions:
http://www.xenocron.com/install/1980.htm
Is this the correct version, since I don't have IABs?
http://forum.pgmfi.org/viewtopic.php?t=5664
Should I disregard this thread? It says it's for vtec and IABs. I noticed it's mostly the same components, but has a decent bit of differences from the other thread.
http://www.xenocron.com/install/1980.htm
Is this the correct version, since I don't have IABs?
http://forum.pgmfi.org/viewtopic.php?t=5664
Should I disregard this thread? It says it's for vtec and IABs. I noticed it's mostly the same components, but has a decent bit of differences from the other thread.
Re: Vtec conversion
You use the standard inputs for a VTEC ECU. http://www.hondata.com/help/smanager/ecuconnectors.htm
For questions about the components and installation you should contact Xenocron Tuning or whoever you got the kit from.
For questions about the components and installation you should contact Xenocron Tuning or whoever you got the kit from.