Page 2 of 2

Re: Hondata s300 red led flashing fast

Posted: Tue May 02, 2017 3:58 pm
by Spunkster
Since you purchased the s300, has it ever worked?

Re: Hondata s300 red led flashing fast

Posted: Tue May 02, 2017 4:02 pm
by jose_mbk
No not yet. The mount a week ago

Re: Hondata s300 red led flashing fast

Posted: Tue May 02, 2017 4:07 pm
by jose_mbk
The Ecu works. The pc detects it. I can upload calibrations. I have both green LEDs on. But the smanager does not read sensors. The engine starts, the car moves. But it does not exceed 2500rpm and goes off in idle.

Re: Hondata s300 red led flashing fast

Posted: Tue May 02, 2017 4:35 pm
by Spunkster
Where did you purchase this s300 from?

Re: Hondata s300 red led flashing fast

Posted: Tue May 02, 2017 4:38 pm
by jose_mbk
A US seller sent me to Spain

Re: Hondata s300 red led flashing fast

Posted: Tue May 09, 2017 8:04 am
by Hondata
Who was the seller? We need to trace the S300 back to us.

Re: Hondata s300 red led flashing fast

Posted: Tue May 09, 2017 8:14 am
by jose_mbk
Already solved. I just had to disable two injector errors and Baro

Re: Hondata s300 red led flashing fast

Posted: Tue May 09, 2017 8:17 am
by jose_mbk
I was not a store seller I was a person who bought it and I did not get to use it

Re: Hondata s300 red led flashing fast

Posted: Tue May 09, 2017 8:19 am
by jose_mbk
Thank you for your attention. Good service

Re: Hondata s300 red led flashing fast

Posted: Sat May 13, 2017 1:43 am
by forevertrj
I just finished having an issue like this, My red light was flashing and no solid green light at the USB connector, what I found was the main board( Green Honda ECU) needs to be clean of all flux used during the socketing process as voltages will bleed to other connectors and cause very erratic behaviors or not even work at all. Also I pulled both hondata and the ecu(green board) out of my aluminum case and tested continuity from the back of the green board to the top of the white(hondata s300 v3) for all the 14 header pins to make sure there was a solid connection. also on the second rail of 14 headers and the 4 pin datalogger header. If issues persists replace the stock ecu's capacitors and again clean the board of all flux or (soldering assist material)