hondata and omnipower 3 bar map

s300 and SManager software questions & answers
newsoltsc
Posts: 98
Joined: Fri Oct 09, 2009 11:49 am
Location: Bay Area, CA
Contact:

Post by newsoltsc »

looks pretty good to me.

282 on 11psi seems good.

Just shift a little before 7k to keep power up.
-Jose
kevin
Posts: 11
Joined: Tue Jul 20, 2010 10:55 am

Post by kevin »

the graph does look good but for this being 2.0 litre motor the numbers dont match up like i said 280 hp on 11 is for like a b16 output
ripperj
Posts: 16
Joined: Sat Jul 17, 2010 11:12 am

Post by ripperj »

The engine is a gsr block with a stock b16a head. Did I say 2.0 somewhere or is it more make believe like the other stuff you posted. The hp loss I will blame on the stock exhaust piping and an autozone axle that was too short and popped out every run. The car is still running perfect, I drive it daily. Once I get some upgrades and Bisimoto opens his dyno back up I will definitely go back and try to reach my goal of 350. My only regret was wasting $200 letting Kevin touch my car but I'm over it now.
kevin
Posts: 11
Joined: Tue Jul 20, 2010 10:55 am

Post by kevin »

if i remember correctly you told me it was a closed deck sleeved block 84mm gsr
Post Reply