W/B AEM --- S300

s300 and SManager software questions & answers
Post Reply
pukai
Posts: 12
Joined: Mon Jan 04, 2010 8:25 pm
Location: PANAMA

W/B AEM --- S300

Post by pukai » Tue Jun 22, 2010 10:07 pm

Gauge Wideband UEGO Controller AEM #30-4100
A QUESTION I WANT TO INSTALL MY CLOCK AEM IN MY S300 WITH P28 I WANT TO KNOW IF I AM BAD I MOVE THE TWO R136 RESISTANCE AND R138 I CONNECT THE WHITE CABLE OF THE W/B TO THE PIN D10 ELD BUT THE CABLE THAT LEAVES THERE I HAVE IT CUTS TO ONLY CONNECT MY W/B OR IT BYPASS? AND IF I MUST FORM SOMETHING IN THE ONLY ACTIVE S300 OR THE READY OPTION AND IF THEY COULD HELP AND THEY EXCUSE MY INGLE ME CHORRERANO BY ALTAVISTA:?: :?: :?: :lol: :lol: :cry: :cry: :oops: :oops:

User avatar
Spunkster
Site Admin
Posts: 17931
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Wed Jun 23, 2010 10:18 am


pukai
Posts: 12
Joined: Mon Jan 04, 2010 8:25 pm
Location: PANAMA

Post by pukai » Wed Jun 23, 2010 8:03 pm

the doubt my is if I have cuts the cable that goes for the sensor of the ELD or I only must it bypass with that sensor?

User avatar
Spunkster
Site Admin
Posts: 17931
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Thu Jun 24, 2010 9:16 am

"0-5V Output from wideband - connect to ELD input making sure that the ELD is no longer connected to it (ELD is pin D10 on an OBD1 ECU)"

Post Reply