SManager V1.4.7 (beta)
Posted: Wed Apr 14, 2010 8:44 am
V1.4.7 (16 April 2010)
Download here
Changes:
• Added crankingfuel tables.
• Added an option to check for beta version updates.
• Correct pressure display psi unit. (Pressure values shown in psi were incorrectly calculated high by approximately 1.2%. Existing calibrations may show corrected values ~1.2% lower, but the underlying pressure values are unchanged, and the calibration will run identically.)
• Added Indicator display type.
• Fixed problem which would occasionally reset ECU depending on parameter options.
• Add instructions for installing a Boost Control Solenoid suppression diode.
• Fixed problem where boost control duty would stay at 0% after gear shift.
Detail:
We've added the complete cranking fuel tables. There is a base pulse table, indexed by coolant temperature, which is then adjusted for cranking rpm and air pressure. From there the pulse is adjusted for injector size and cranking fuel trim.
Check for updates now can check for beta updates as well.
Don't panic with the change in the psi pressure units - it is display only. Only don't need to re-tune your car.
A new display type, the indicator, allows you to show on/off conditions.
However, the indicator is not limited to just on/off sensors. You can use the warning max and min to show other conditions. eg a shift light
Lastly, we've fixed a problem where the ECU would reboot (very quickly) from time to time, depending on the exact parameter settings and engine speed. I'd like people to test this version as well to see if this was also causing the boost control inconsistencies.
Download here
Changes:
• Added crankingfuel tables.
• Added an option to check for beta version updates.
• Correct pressure display psi unit. (Pressure values shown in psi were incorrectly calculated high by approximately 1.2%. Existing calibrations may show corrected values ~1.2% lower, but the underlying pressure values are unchanged, and the calibration will run identically.)
• Added Indicator display type.
• Fixed problem which would occasionally reset ECU depending on parameter options.
• Add instructions for installing a Boost Control Solenoid suppression diode.
• Fixed problem where boost control duty would stay at 0% after gear shift.
Detail:
We've added the complete cranking fuel tables. There is a base pulse table, indexed by coolant temperature, which is then adjusted for cranking rpm and air pressure. From there the pulse is adjusted for injector size and cranking fuel trim.
Check for updates now can check for beta updates as well.
Don't panic with the change in the psi pressure units - it is display only. Only don't need to re-tune your car.
A new display type, the indicator, allows you to show on/off conditions.
However, the indicator is not limited to just on/off sensors. You can use the warning max and min to show other conditions. eg a shift light
Lastly, we've fixed a problem where the ECU would reboot (very quickly) from time to time, depending on the exact parameter settings and engine speed. I'd like people to test this version as well to see if this was also causing the boost control inconsistencies.