Page 1 of 1

k24 rsx map ?

Posted: Mon Jul 20, 2015 7:00 pm
by tylermep3
can anyone help me out with a k24 map for my rsx specs below much appreciated

k24a2
shorty header
2.5" exhaust
rbb intake manifold
70mm throttle body
short ram

Re: k24 rsx map ?

Posted: Fri Aug 21, 2015 12:56 pm
by davinadze
got one tuned for k24/k20 maybe it will help. got one 520cc injectors and 310cc

520cc injectors. k24/k20a2 head, tsx 06+ cams, RRC maniforld/70mm port matched TB, 4'' custom short ram-cold air intake, Tri-Y header to 3" exhoust.

Re: k24 rsx map ?

Posted: Fri Aug 21, 2015 1:00 pm
by davinadze
310cc injectors. k24/k20a2 head, tsx 06+ cams, RRC maniforld/70mm port matched TB, 3.5'' custom short ram-cold air intake, Tri-Y header to 3" exhoust.

Re: k24 rsx map ?

Posted: Wed Oct 14, 2015 1:29 pm
by olivenoire
It is really great for you to share a map.
People must be advice to add a bit fuel or remove timing before upload...

Great anyway!

Re: k24 rsx map ?

Posted: Sun Mar 04, 2018 5:34 pm
by 5j0k3r
Is this for a k24a? Or What k24 is it for?

Re: k24 rsx map ?

Posted: Sun Apr 08, 2018 5:21 pm
by Buffep3
Runs great but my check engine light flashes here and there randomly

Re: k24 rsx map ?

Posted: Sat Dec 15, 2018 1:08 pm
by Danksanatra
I tried to use this tune, but kept getting knock and I can't wot without hitting lean protection close to 5k rpm
Setup

K24a/k20a2
06 tsx cams
Vtc-50
Ktuned race header to 3” exhaust
Rbc manifold

Re: k24 rsx map ?

Posted: Fri Dec 28, 2018 6:31 pm
by rufer
I have a 02 RSX Type S I recently swap my K20a2 with a JDM K24A, I have Kpro V4 I tried the MAP for RSX with K24A2 intake and headers I think but it kept bringing up my Speed sensor check engine light, So I Finally use under Others TSX STOCK CAL and it work fine for 2 months, so I recently put my previous Cut RBC manifold with Hondata IMG, I had to get the Ktune coolant adapter and connected my Injen CAI, the car run good for 1 week now is running lean and rich most of the time also stalls at idle and while running, I'd been researching on google and here and cannot seem to find any solution to my problem, is there a better fitted calibration or tune preloaded on KPRO that I can use? again my mods are:

stock RSX type S transmission
JDM K24A Motor with Original Fuel Injectors
CUT RBC manifold with KTUNE coolant adapter (if that makes any difference)
Injen CAI
Kpro V4