Page 1 of 1

Rsx-S Primary 02 sensor voltage

Posted: Mon May 23, 2005 5:30 pm
by hardcorersxs
Doug/Derek

Do you know the output voltage for the primary o2 sensor? The reason i ask is that i found this information.

Mikey

Posted: Tue May 24, 2005 9:32 am
by Spunkster
The primary o2 is current based and not voltage based. THe PLX will not work for the K-Pro.

Posted: Tue May 24, 2005 12:11 pm
by Hondata
If you wire anything other than the stock o2 sensor into the ECU, you will burn out the o2 controller in the ECU.

Posted: Thu Jun 02, 2005 8:27 am
by sprinto7
Hondata wrote:If you wire anything other than the stock o2 sensor into the ECU, you will burn out the o2 controller in the ECU.
Is it possible the repair the ECU after the O2 controller has been fried?
Del Long

Posted: Thu Jun 02, 2005 9:18 am
by Spunkster
No it is not. You will have to buy another ecu.

Posted: Thu Jun 02, 2005 1:47 pm
by sprinto7
Spunkster wrote:No it is not. You will have to buy another ecu.
What would it cost to have the KPro tranferred to a different ECU.
This one works fine, except for the A/F reading.
Del Long

Posted: Thu Jun 02, 2005 4:16 pm
by Spunkster
The policy will be that you send your damaged ecu withthe K-Pro to us along with a working ecu and for $100 we will transfer the K-Pro to the new ecu and we will then keep and destroy the damaged ecu as we do not want them being resold and causing us and others problems in the future.

Posted: Fri Jun 03, 2005 5:56 am
by sprinto7
Spunkster wrote:The policy will be that you send your damaged ecu withthe K-Pro to us along with a working ecu and for $100 we will transfer the K-Pro to the new ecu and we will then keep and destroy the damaged ecu as we do not want them being resold and causing us and others problems in the future.
No problem, I'll start searching for replacement ECU. Then when the Autocross season is over I'll send them both in.
Thanks.
Del Long