Is the MAP data log value actual sensor reading or calculated value with Alpha-N?
Data log MAP value looks like a calculated value from the TPS.
(if the data log is the calculated value), How can I check MAP sensor operation with Alpha-N?
Thanks!
MAP Data log value with Alpha-N
MAP Data log value with Alpha-N
- Attachments
-
- URGE 07052021a.kal
- (163.87 KiB) Downloaded 56 times
-
- 07052021 engine stop3.kdl
- (344.62 KiB) Downloaded 54 times
-
- MAP-TPS.jpg (260.93 KiB) Viewed 575 times
Re: MAP Data log value with Alpha-N
You will not get an actual reading, as it is a hybrid value based on the 2 signals: http://www.hondata.com/help/kmanager/ma ... tsub=alpha
Re: MAP Data log value with Alpha-N
I'm having the same issue.Spunkster wrote: ↑Tue Jul 06, 2021 1:10 pm You will not get an actual reading, as it is a hybrid value based on the 2 signals: http://www.hondata.com/help/kmanager/ma ... tsub=alpha
My question (which doesn't seem to get answered) is why does this 'MAP trace' look exactly same with the map sensor unplugged??
It also begs the question as to why it's needed etc
Re: MAP Data log value with Alpha-N
And then I'm told to set the throttle open and closed values with the engine off, which don't have any changes. Only with the engine on do these 'MAP values' change with throttle.
Re: MAP Data log value with Alpha-N
Then set the values with the engine running.
Re: MAP Data log value with Alpha-N
Thank you very much for the help!