Hondata kpro4 4000 rpm limit and no ignition in kmanager

K-Series Programmable ECU installation questions / support issues
Post Reply
svr
Posts: 2
Joined: Sat Mar 13, 2021 5:07 am

Hondata kpro4 4000 rpm limit and no ignition in kmanager

Post by svr »

Hello everyone

I have a client car in, with a hondaata installed.
The car has a revlimiter on 4000 rpm and also if i try to connect kmanager, driver installed/ecu online but ignition off. Car runs only 4k limiter, but as i can't connect, i can't see faults ect.
I checked voltage on pin 9 of e connector and i got 12v

Any ideas
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Hondata kpro4 4000 rpm limit and no ignition in kmanager

Post by Spunkster »

What is the serial number that is on the K-Pro board inside the ECU?
svr
Posts: 2
Joined: Sat Mar 13, 2021 5:07 am

Re: Hondata kpro4 4000 rpm limit and no ignition in kmanager

Post by svr »

48270
I discovered that the ecu is getting 12v, ign and ground but the kpro board isn't. The in with the single wire soldered to it, only gets 0.78 v
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Hondata kpro4 4000 rpm limit and no ignition in kmanager

Post by Spunkster »

You also emailed us, and we have replied to your email.
Post Reply