Hi, have a K20a2 that wont go in closed loop,
PRC ecu
Kpro v4 with software 4.4.4
Innovate LC-2 widebandlambda
E85
Wont go in closed lopp
Re: Wont go in closed lopp
You have short term trims in the datalog so closed loop appears to be working.
-
- Posts: 48
- Joined: Thu Aug 09, 2007 6:06 am
Re: Wont go in closed lopp
But it wont adjust to 14.7.
Re: Wont go in closed lopp
Look at the fuel status. 2 is closed loop.
It runs in closed loop for the first minute, then after the restart it again goes into closed loop again.
I'd look at the injector dead times first and then why there is a -20% fuel trim.
It runs in closed loop for the first minute, then after the restart it again goes into closed loop again.
I'd look at the injector dead times first and then why there is a -20% fuel trim.
Hondata