95 K20a Bogging at times - KPRO Change needed?

K-Series Programmable ECU installation questions / support issues
User avatar
Spunkster
Site Admin
Posts: 17861
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: 95 K20a Bogging at times - KPRO Change needed?

Post by Spunkster » Tue Jun 18, 2019 1:38 pm

Try only making changes to the gear multiplier.

mistaphace
Posts: 10
Joined: Mon Oct 29, 2018 11:33 am

Re: 95 K20a Bogging at times - KPRO Change needed?

Post by mistaphace » Wed Jun 19, 2019 7:40 am

This morning I tried setting all gears to 0 and -100 that seemed to make the car almost undriveable.

After searching I found a recommendation to use these parameters:
-60, -75, -90, -100, -100, -100

When testing driving, it bogged at the very beginning then smoothed out. Should I adjust it more?

I am thinking I can adjust 1st gear, but I am not sure if I go -50 or -70.

Thanks.
Attachments
Tip in Change #1.kdl
(1.97 MiB) Downloaded 11 times

Post Reply