K swapped ef (91 wagon) with crv trans (using oem cable vss) running base rsx (manual) wiring harness and a56 (base auto) kpro ecu v4. Depinned a18 white/green and ran to the internal kpro board on vss (red). Changed under misc to alternate speed input. Followed the exact guide here.
https://www.hondata.com/tech-alternativ ... ngine-swap
Kpro app and laptop show 0 vss when driving
Thanks
Kpro speedo vss
-
- Posts: 10
- Joined: Wed Mar 04, 2020 3:39 pm
Re: Kpro speedo vss
Also stock cluster shows no speed also
Re: Kpro speedo vss
If you are using a cable VSS, how is any signal getting to A18?
-
- Posts: 10
- Joined: Wed Mar 04, 2020 3:39 pm
Re: Kpro speedo vss
Good question probably doesn't. B16 on the oem ef harness (speed sensor) from or to cluster gives a signal
https://www.nthefastlane.com/honda-obd0 ... cu-pinouts
https://www.nthefastlane.com/honda-obd0 ... cu-pinouts
Re: Kpro speedo vss
You need to determine how the wiring is routed in your vehicle. There is more than just the wire at the ECU involved in your setup.
-
- Posts: 10
- Joined: Wed Mar 04, 2020 3:39 pm
Re: Kpro speedo vss
Back of the cluster has a cable that goes right into the transmission with a d series cable speed sensor. The d series cable sensor is a drop in for all k series transmissions. The only way to get the cluster speedo is to tap the b16 vss (yellow) from the link above to the a18 vss (white green).
I got the cluster to show speed now
The problem is the vss in kpro won't show anything.
I got the cluster to show speed now
The problem is the vss in kpro won't show anything.
Re: Kpro speedo vss
You will need to get the signal from the cluster to the ECU, as that wiring appears to be missing.
-
- Posts: 10
- Joined: Wed Mar 04, 2020 3:39 pm
Re: Kpro speedo vss
Very well. I'll keep looking into it. Thanks