Hondata

With the new Version, the Datalogs are very big (1h = over 650 MB).
Not always, but from time to time!

Please fix this bug!

With the 64 bit version, the datalogs are very, very big of size!

On the 64-bit version, the flashpro help is crashing!

mladjan wrote: ↑Tue Oct 10, 2017 12:09 pm Great video! One question: If Im using hybrid calibration, do I need to enable AT for AFM too?

Yes!

Thank you! :)

Currently it is as follows: If a gear is engaged, the car can also be started with the start button. So it does not matter, if a gear is engaged or not, because the car can always start. But, it should be as follows: If a gear is engaged, starting with the start button should not be possible. Only ...

Dead times look low (1.05ms @ 14V for 750cc), and the MAP takes some time to fall once the throttle is shut, but the main problem is closed loop oscillation. This is from one or more of o2 sensor placement, o2 sensor condition, injector dead times, injector spray pattern, exhaust temperature, fuel ...

The active tuning tables were sucessfully downloaded from FN2 ECU, although some attention is needed to this points: Maximum load and Maximum lambda is fixed, unable to change; Minimum values could be greater than Maximum values; Restrict maximum values to calibration; Example: When insert Maximum ...

The primary o2 sensor has been replaced one week ago. The DT are from the manufacturer (ASNU) like this: http://www.asnu.com/static-downloads/injectordata/ASNU%20750cc%20DF%203%20BAR.pdf http://www.asnu.com/static-downloads/injectordata/ASNU%20750cc%20LD%203%20BAR.pdf http://www.asnu.com/static-down...

Hi Hondata, i have a similar problem on FN2 with Rotrex S/C and ASNU-Injectors (map & log i have send to you via email). I have marked in the log, where I started pushing the clutch and where I have stopped pushing the clutch. You can see, the rpms jumps up and down, while the clutch is permanen...

In this case, it's a FN2/K20Z4, which do not have a idle valve!
The idle is only controlled by the ECU at the FN2!

Is there also a solution for this?

This in normal on the FN2.
It is for securitiy purposes.

The error code is only displayed, if you press the play button in the graph window!

"Return to stock" is only possible with the Flashpro Manager together with a Notebook!

The curious thing about this problem is, that WOT (is still the same), but only the afm-fuel was too rich. I had to go 10-12% leaner in afm-fuel, to reach the previous values. Could the problem be related to the changes for my Flashpro, because of the following datalog-problem, which I had: https:/...