Hondata

Guys,

The 9th Gen Si (ECU) A21 and A22 needs the speedometer adjustment for Dash. Our Forged gearboxes have different Teeth ratio.
Same car, the cranking fuel tables should help cranking on E100.

To the 8th gen civic a Fuel Compensation for gear should work fine for race calibrations.

Thanks Guys,

Ill check it out before going ahead!! Yep .. I do Speak portuguese! lol !!

Cheers,

My Bad Guys,

Wrong datalog. here the correct one. Bellow the point of cut.

Same Seen here !!!

Hi Guys, I dont know why ... But this calibration is cutting the injectors like on launch control. BTW, i've recheck all the calibration again and, still the same condition. No clue about what is going on .. We've check the clutch switch and etc .. When Getting up a basemap, still got the same cut. ...

Hi Guys,


Ive the same question. ECU PN:

37820-5AA-M51

Thanks in advance,

Matt is out this week but we will process the support emails today. A FlashPro can only be unlocked with the ECU it was locked to. If the ECU was destroyed in a collision we encourage you to claim the FlashPro as part of the insurance claim. If the FlashPro was purchased used and locked then you sh...

Matt is out this week but we will process the support emails today. A FlashPro can only be unlocked with the ECU it was locked to. If the ECU was destroyed in a collision we encourage you to claim the FlashPro as part of the insurance claim. If the FlashPro was purchased used and locked then you sh...

Spunkster wrote:Send an email to support <at> Hondata.com with the serial number and your question.

Spunkster .. I Sent your support two emails with no answer, would you mind helping me with the reply?!

Thanks,

Actually not yet ...

I was wondering how the throttle process table works. BTW Ill do that and reset the values.

Thanks,

Guys, After some changes on Throttle parameter I'm facing some Idle floating. Do you have some advice on how to work to reduce TP lag and keep it stable? Here the calibration: Setup: Tyres: 225/50/17 TurboCharger - K24 - T04 -> Custom Intake Fuel: E 100% Injectors: Bosch 160lbs Exhaust - Custom Made...

Thanks by the prompt answer There's no mechanical lock, we measure the contact with the piston at TDC we can advance the Intake 7 chain tooth to have contact. Assuming each tooth is 15 degrees, theoretically there's room for 3 degrees, that's when it starts ticking. The head is open now and just che...

Guys, I Just Overhaul my engine and After the final assembly the Cold Rattle of the VTC actuator was driving me crazy. I Changed the Part but now, Every time I Insert more than 3 degrees on the my calibration, I can hear the sound of piston to valve contact. Including in idle. When Running the engin...

I´ll do that! Thanks for your support!!!

Hi Guys, I was wondering over the corrected ethanol target lambda and AFR over Stock K20 WB. Stoich - Lambda 1 Max Power Lean - Lambda 0.7 Max Power Rich - Lambda 0.87 The Stock WB will read AFR as: Stoich - 9:1 Max Power Rich - 6.43:1 Max Power Lean - 7.8:1 ???? I´m really confuse once when mixing ...