Search found 19425 matches

by Spunkster
Thu Mar 04, 2021 12:40 pm
Forum: FlashPro Manager
Topic: R18A2 Turbo project - which ECU
Replies: 1
Views: 14

Re: R18A2 Turbo project - which ECU

We do not recommend or support swapping US ECU's into vehicle from unsupported regions.
by Spunkster
Wed Mar 03, 2021 4:43 pm
Forum: Civic Si 2006-2011 Americas
Topic: Unknown SRI, safe to flash basemap?
Replies: 5
Views: 36

Re: Unknown SRI, safe to flash basemap?

There is quite a bit of information in the tech section of the website:

https://www.hondata.com/technical-information
https://www.hondata.com/tech-k-series
by Spunkster
Wed Mar 03, 2021 12:13 pm
Forum: Civic Si 2006-2011 Americas
Topic: Unknown SRI, safe to flash basemap?
Replies: 5
Views: 36

Re: Unknown SRI, safe to flash basemap?

You can try different calibrations and see how it runs.
by Spunkster
Wed Mar 03, 2021 12:12 pm
Forum: FlashPro Calibrations
Topic: 2020 civic si coupe error on dash
Replies: 24
Views: 286

Re: 2020 civic si coupe error on dash

Hondata wrote: Tue Mar 02, 2021 8:26 am Post a datalog from a 10 minute drive.
by Spunkster
Tue Mar 02, 2021 10:00 am
Forum: Applications
Topic: Iat going crazy
Replies: 8
Views: 50

Re: Iat going crazy

You can try it.
by Spunkster
Mon Mar 01, 2021 5:25 pm
Forum: K-Pro / KManager
Topic: S2K AP1 K Pro O2 sensor
Replies: 7
Views: 2028

Re: S2K AP1 K Pro O2 sensor

It's not a problem as it cannot read an AF from a narrowband sensor. This is completely normal for it to show this reading.
by Spunkster
Mon Mar 01, 2021 12:22 pm
Forum: s300 / SManager
Topic: S300 v3 no datalog and 4000rpm rev limit
Replies: 5
Views: 45

Re: S300 v3 no datalog and 4000rpm rev limit

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
include a link to this thread
by Spunkster
Mon Mar 01, 2021 12:06 pm
Forum: Applications
Topic: Iat going crazy
Replies: 8
Views: 50

Re: Iat going crazy

I would not recommend changing the ground locations for this as it may cause a ground loop. If you suspect a damaged wire, then it would be best to replace that wire back to where it should go on the ECU.
by Spunkster
Mon Mar 01, 2021 12:02 pm
Forum: K-Pro / KManager
Topic: KPRO V4 running lean problem
Replies: 13
Views: 2314

Re: KPRO V4 running lean problem

It may just be a issue with that AEM wideband. I only recommend using the PLX widebands.
by Spunkster
Mon Mar 01, 2021 11:59 am
Forum: s300 / SManager
Topic: S300 v3 no datalog and 4000rpm rev limit
Replies: 5
Views: 45

Re: S300 v3 no datalog and 4000rpm rev limit

Is J12 cut on the ECU?
by Spunkster
Mon Mar 01, 2021 11:57 am
Forum: K-Pro / KManager
Topic: S2K AP1 K Pro O2 sensor
Replies: 7
Views: 2028

Re: S2K AP1 K Pro O2 sensor

It does run in closed loop form the narrowband sensor, but a narrowband cannot give an accurate AF reading like a wideband can.
by Spunkster
Mon Mar 01, 2021 11:47 am
Forum: FlashPro Manager
Topic: 8th gen si launch control problem
Replies: 1
Views: 19

Re: 8th gen si launch control problem

Check your clutch switch as it may be broken or not making good contact.
by Spunkster
Fri Feb 26, 2021 5:51 pm
Forum: K-Pro / KManager
Topic: Aim mxs 1.2 kpro v3 issue
Replies: 4
Views: 32

Re: Aim mxs 1.2 kpro v3 issue

You will need a logic analyzer to test that.
by Spunkster
Fri Feb 26, 2021 4:04 pm
Forum: K-Pro / KManager
Topic: Aim mxs 1.2 kpro v3 issue
Replies: 4
Views: 32

Re: Aim mxs 1.2 kpro v3 issue

Have you read the info in the help file: http://www.hondata.com/help/kmanager/mu ... =multiplex
by Spunkster
Fri Feb 26, 2021 11:32 am
Forum: Civic 2016+ 1.5 Turbo Americas/Asia
Topic: Base Map Modifications Throttle
Replies: 4
Views: 75

Re: Base Map Modifications Throttle

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.