Search found 10 matches

by TeknoJunki
Thu Jul 15, 2004 8:29 am
Forum: s100/s200
Topic: AEM Wideband problem.
Replies: 21
Views: 23566

does anyone have information on the range that the hondata is expecting to see for A/F ratios? i have another wideband with an adjustable output that i have not yet hooked up and would like to have the appropriate output if someone has the info already.

thanks
by TeknoJunki
Thu Jul 15, 2004 8:28 am
Forum: s100/s200
Topic: AEM Wideband problem.
Replies: 21
Views: 23566

does anyone have information on the range that the hondata is expecting to see for A/F ratios? i have another wideband with an adjustable output that i have not yet hooked up and would like to have the appropriate output if someone has the info already.

thanks
by TeknoJunki
Wed Apr 21, 2004 8:42 pm
Forum: s100/s200
Topic: idle tuning/surging
Replies: 6
Views: 2847

edlocke: no problems with the cooling system

bakeoff: i suppose it might be normal, but it seems strange that it would warm up just fine without a load, but only starts bouncing if i tap the throttle or turn the A/C on
by TeknoJunki
Fri Apr 09, 2004 6:27 pm
Forum: s100/s200
Topic: idle tuning/surging
Replies: 6
Views: 2847

I think the thermostat is a colder one, it came with the JRSC stage 1 boost kit. I have no idea at what temp it starts to open though. About the tuning, I'm going to wait until I can get a WB O2 to do it myself. For the most part the car runs well maybe a bit on the rich side, but none of the proble...
by TeknoJunki
Wed Apr 07, 2004 8:06 pm
Forum: s100/s200
Topic: idle tuning/surging
Replies: 6
Views: 2847

idle tuning/surging

I'm using the base map for the JRSC on a d16y8 in a 98 EX. I have a problem with the idle surging when it's not fully warmed up. The surging will only start if there's a load on the engine from the A/C or defroster, or if I give it some gas. The surging stops once the water temp stabilizes. If I sta...
by TeknoJunki
Tue Feb 17, 2004 12:11 am
Forum: s100/s200
Topic: i apologize if this seems dumb...
Replies: 1
Views: 1203

i apologize if this seems dumb...

how do i set the timing with a hondata ecu? i know for the stock ecu the service connector on the harness needs to be shorted with a jumper and then the IAC needs to be unplugged in order to read the timing properly. is the process the same with the hondata ecu? perhaps i just have to do my best and...
by TeknoJunki
Thu Jan 08, 2004 8:47 pm
Forum: s100/s200
Topic: Other unused sensors
Replies: 0
Views: 1009

Other unused sensors

Since the Hondata system is based of a OBD 1 system I am assuming that the secondary O2 sensor is not used and the wiring is just ignored. I am planning on buying an aftermarket catalytic converter, so I wanted to see if I should even bother having a bung put in for the other sensor. Can I just remo...
by TeknoJunki
Thu Dec 11, 2003 9:50 pm
Forum: s100/s200
Topic: a few knock sensor questions/concerns
Replies: 3
Views: 1818

something else

I just noticed after looking at the ECU swap table that the knock sensor is deactivated on a stock ECU above 5000rpm due to the inability to distinguish knock from engine noise. Does the Hondata ECU do this as well? If not how does it deal with the noise? If anyone has any experience with the J&S, d...
by TeknoJunki
Thu Dec 11, 2003 9:02 pm
Forum: s100/s200
Topic: a few knock sensor questions/concerns
Replies: 3
Views: 1818

a few knock sensor questions/concerns

I have recently ordered a s200 from moss performance for use on a d16y8 with a JRSC, and yes I know there are many more options for better power but this is what I'm working with. In any case I wanted to find out what was available for a knock sensor. The stock block does not have a knock sensor nor...
by TeknoJunki
Mon Nov 17, 2003 1:39 pm
Forum: s100/s200
Topic: pre-installation questions
Replies: 0
Views: 913

pre-installation questions

I am planning on purchasing the hondata upgrade package for the JRSCand eventually increasing the boost. It's going on a D16Y8 from an EX and I was curious to see if there are others on this forum that have increased the boost from the standard 6psi. What I'd like to know is whether or not the stock...