Search found 17 matches

by Prizm5063
Tue Nov 24, 2009 3:52 pm
Forum: Civic Si 2006-2011 Americas
Topic: RDX Injector Dead Times
Replies: 4
Views: 7114

Is there a similar method for doing this if you're already in a modified or boosted setup? Perhaps from 1 of the base calibrations?
by Prizm5063
Tue Nov 17, 2009 9:06 pm
Forum: Civic Si 2006-2011 Americas
Topic: idle problem
Replies: 6
Views: 3097

Did the best I could. Where the afr dips go 15+ the dan is trying to turn on and it just bogs over and over.
by Prizm5063
Sat Nov 14, 2009 9:05 pm
Forum: Civic Si 2006-2011 Americas
Topic: idle problem
Replies: 6
Views: 3097

07 Honda civic Si CT-E Supercharger kit, 3.6 inch pulley, RC 650 CC injectors with clips, Vibrant Header w/ High-flow Cat, CT-E intake (approx 20k miles on SC) Flashpro Serial Number: FP-SI-US-10164 Below is the current state of my tune. This is still in process. The idle data log was all I could ge...
by Prizm5063
Sat Nov 14, 2009 9:01 pm
Forum: Civic Si 2006-2011 Americas
Topic: RDX Injector Dead Times
Replies: 4
Views: 7114

Not sure. i used the dead times from the Injector-Rehab website on my 650cc injectors. Complete difference from factory settings. and I'm not sure if those are saturated or non-saturated. I asked RC engineering for stats and they only test at 13.5 volts. So I switched back to the factory settings si...
by Prizm5063
Sun Nov 08, 2009 9:35 pm
Forum: Civic Si 2006-2011 Americas
Topic: idle problem
Replies: 6
Views: 3097

Having the same problem. i'll take a datalog tomorrow and upload it. Everytime the fan tries to kick on, the idle begins to bounce.
by Prizm5063
Tue Nov 03, 2009 12:36 pm
Forum: Civic Si 2006-2011 Americas
Topic: Injector opening and closing times
Replies: 1
Views: 1981

Injector opening and closing times

Since these were not provided, should they have been for upgraded injectors or are the times in flashpro considered an average or standard time? I've upgraded to 650CC RC injectors and I'm wondering if these times need to be updated?
by Prizm5063
Fri Oct 30, 2009 10:41 am
Forum: Civic Si 2006-2011 Americas
Topic: Stage 2 CT-E calibration running Lean,
Replies: 9
Views: 5175

Ok, I'm going to look like at idiot here but... what? I haven't touched the MAP sensor since the SC was put on about 20k ago. Ran fine with the originaly stage 1 tune and I am seeing boost in my data logs. As far as I know it's located correctly. Can you explain how it could be done incorrectly and ...
by Prizm5063
Fri Oct 30, 2009 10:31 am
Forum: Civic Si 2006-2011 Americas
Topic: Stage 2 CT-E calibration running Lean,
Replies: 9
Views: 5175

Well, I replaced the A/F sensor, no luck in the base map being accurate. i was running really lean, like 15:1 under boost. So, I added RC 650CC injectors and a walbro fuel pump with no luck. So, I adjusted the fuel maps to get rid of the lean issues and I'm just tweaking them now. I have a new Fuel ...
by Prizm5063
Thu Oct 22, 2009 6:26 pm
Forum: Civic Si 2006-2011 Americas
Topic: Stage 2 CT-E calibration running Lean,
Replies: 9
Views: 5175

Ok, i replaced the A/F sensor, and had a little bit better luck but still running a bit lean. I'll adjust per Punkster's request before and try again.
by Prizm5063
Wed Oct 21, 2009 11:44 am
Forum: Civic Si 2006-2011 Americas
Topic: Stage 2 CT-E calibration running Lean,
Replies: 9
Views: 5175

I used those numbers recommended, with slightly better results but not quite there. See the attached data log. The point in question is from 1:15 to 1:36. Another individual pointed out that he had this same problem and his O2 sensor had gone bad. I will attempt to replace this and see what happens ...
by Prizm5063
Tue Oct 13, 2009 9:12 am
Forum: Civic Si 2006-2011 Americas
Topic: Stage 2 CT-E calibration running Lean,
Replies: 9
Views: 5175

Stage 2 CT-E calibration running Lean,

07 Honda civic Si CT-E Supercharger kit, 3.6 inch pulley, modified stock injectors, Vibrant Header w/ High-flow Cat, CT-E intake (approx 20k miles on SC) Flashpro Serial Number: FP-SI-US-10164 History: Originally ran the stage 1 flash, when I read that the injectors were running at 100% duty cycles ...
by Prizm5063
Fri Oct 09, 2009 4:50 pm
Forum: Civic Si 2006-2011 Americas
Topic: Lost Expanded Tables for boost
Replies: 2
Views: 1834

Ok, feel like an idiot.

Edit: Rest of the message has been posted in a new post.
by Prizm5063
Fri Oct 09, 2009 2:42 pm
Forum: Civic Si 2006-2011 Americas
Topic: Lost Expanded Tables for boost
Replies: 2
Views: 1834

Lost Expanded Tables for boost

Upgraded to version 8 and beta 9, and I've lost the expanded tables for boost on all MAP based calibrations. Tabe goes from -89 KPA to 0.2 psi (above atmospheric) INFO to come in a minute Flashpro Serial #: FP-SI-US-10164 07 Civic SI, FA5, US domestic Modifications: CT-SC stage 2 with 3.6" pulley, C...
by Prizm5063
Wed Aug 19, 2009 8:44 pm
Forum: Civic Si 2006-2011 Americas
Topic: RDX Injectors
Replies: 6
Views: 4030

Ok. I sort of understand you but I'm going to ask further. When you set the previous injector size, and the new injector size, what does this do exactly? Is it just a reference? So a very possible scenario, let's say my tune is setup for 520CC injectors (CT stage II) and I want to move to 650CC inje...
by Prizm5063
Sun Aug 16, 2009 6:46 pm
Forum: Civic Si 2006-2011 Americas
Topic: RDX Injectors
Replies: 6
Views: 4030

So it will automatically adjust the tables or flow rate for the new injectors? Question, in the fuel tables it states volumetric efficiency. Is this for the engine? is it adding fuel based on this number? is this volumetric efficiency for the injectors? Just trying to understand this value and what ...