Hondata

Thank you for the assistance, it is functioning correctly now.

Can I do that, with the TC Input set to "None"? Otherwise car is next to impossible to drive?

I'll try that soon here, thanks. IS the correct method to set the wheel speed set up to press "set" then "apply changes to TC" near the top of the window and that's it?

I am using 1.7.2 Before my car went to the shop, its was connecting with FPM, I am not sure if this is what they used to setup the wheel speed setup.

So where do I go from here?

Had this installed today and I'm having some issues. With the TC dial off, it is engaging ignition cut. The only way I can drive without major issues is to turn the TC Input from ELD to None under Traction control in FPM Also, the TC window within FPM keeps saying Traction Control (disabled - softwa...

So I am having an issue with the displayed sensor data for the Wideband. It pretty much just stays at or within a couple tenths of 10.50..this is with the primary o2 all over the map. Any idea on what would cause this?

No worries, Ok, thanks for the clarification.

Thanks, is there a way I can still monitor what the primary o2 is doing for comparison?

Thanks, so no need to use the AF corrected anymore right?

Another question came to mind and I couldn't find an answer.

When reviewing a datalog with the WB hooked up to the ECU, which value or sensor will depict the data it has recorded in FPM? Will it replace the current AFR or AFR corrected values?

Thank you for the quick response, you are always very helpful :)

Thanks!

So just so I am clear. Would I input the following?

0V / 4.99V
Lamda (:1)10 / 19.98

Wideband votlage input as ECT2? I intend to use ECT2/ pin A44

and disable ECT2 under MISC settings?

Hello, I am wanting to use my AEM Wideband (30-4100) for datalogging via FP. I will be using the A44 ECT2 Pin out as my ELD will be used for your TC system. Can you please confirm what if any values I would have to input into Voltage cells and Lambda (:1) cells? http://www.aemelectronics.com/Images/...

Thanks!

Hello, I wanted to check to ensure you did receive my S.A.S.E and hoping that it has been sent back. Could you please advise? Thanks.