Hondata

HI

Is it possible add flat shift cut function on Flashpro?
going to install Sequential gear box on FD2

Thanks
KL

Boot command drops a lot with VTEC so the ECU uses the throttle to control boost. try everything to CMBP higher but still doing the same WOT the Tplate still off half to try lower my boost. always around 4500rpm start off Tplate. boost PA disable R+ mode VSA and TC fully off is it the Honda TC stil...

Hondata wrote: ↑Sun May 22, 2022 6:51 am Boot command drops a lot with VTEC so the ECU uses the throttle to control boost.

Request more throttle toq to make the boost CM higher?

Thanks a lot you help!

Kl

FK8 full throttle pedal 100% but the Tplate off to 53%, R mode with TC fully off, what can cause this throttle plate off and on?

thank you

is it possible make the software can choose cut fuel or cut ignition (including -% IGN ), now i'm using this fuel cut function feel the shift level pretty hard and a bit slow to reactive the power, compare to my friend's car same sequential box just different ecu with ignition cut it feel more soft ...

Is it possible make the software can change cut fuel or cut ignition (including -% IGN table), now i'm using this fuel cut function feel the shift level pretty hard and a bit slow to reactive the power, compare to my friend's car same sequential box just different ecu with ignition cut it feel more ...

is it possible make the software can pick cut fuel or cut ignition (including -% IGN table), now i'm using this fuel cut function feel the shift level pretty hard and a bit slow to reactive the power, compare to my friend's car same sequential box just different ecu with ignition cut it feel more so...

For Sequential shift cut request IGN cut is it possible also Rev Limits?

Thank you !

2020 FK8 is it possible to see oil temp on datalog or display?

thank you!

On the graph add comment how can change the color of the text? please see below, thanks!

i'm using P30 ECU with Knock sensor, i can see the knock level and knock retard on Display only, is it possible add Knock table able to change the value for sensitivity and retard?

Thank you!

I'm using AEM wide band digial input, i cannot find digial channel on datalog Graph, only can see on Display only.

bestlap wrote: ↑Tue Aug 11, 2020 7:02 am IOS mobile app can see the analog sensor input Channel ?

@hondata