Hondata

The romeditor 4 only works with the hondata cable and the romeditor 4 don't save the bin until the right cable is plug in the pc.

This is what you need

1-Email Hondata the # of your S200 box and ask for what is enable in your box. 2-If the box have boost and dataloging enable buy the RomEditor 4 and tune your car. 3-If you have a basic S200 you have to purchase the boost and dataloging options. Mod to your ecu. Solder the 4 pin on the CN2 spot and ...

Only if you use a V3 bin

Just tap a wire between D6 and A4. The B16B don't have the vtec pressure switch.

Can you post some pics of inside the ecu.

It hapens to me once and the solution was a thicker line to feed the vtec.

To Jaker.
Do you have the bin from your TCS ECU ?
Could you send me that bin?
Thanks.

rosa.caamano@verizon.net.do

I have a corporate version of the McAfee and when I try to download the 1.1.1.0 from the your site it showme a virus alert.
What to do?

Thanks.

Or and amp for hearing impare $15 at Radio Shack.

Are you going to sell your laptop with the software because one of the problem is that you going to sell a software with no key enable and Hondata will not enable the software for free because you decide to change to S300 and BTW they are going to realese a V4 with all the feature of the S300 for th...

Hold down clip outside the ecu for the big ecu type and for the small(JDM) the hold down clip facing the prossesor.

If you have a resistor in RP17 and RP18 is AT to convert remove RP17 and place a jumper on RP18.

You can convert the ecu from AT to MT

Sorry to say you this but that ecu is a P06.