Search found 211 matches

by curtusz
Sat Dec 18, 2021 8:33 am
Forum: FlashPro Manager
Topic: FlashPro Requests
Replies: 365
Views: 453451

Re: FlashPro Requests

How about f-Manager for Android

Phones and tablets last so much longer on battery life and so much easier to carry around than laptops.
by curtusz
Sat Dec 18, 2021 8:21 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Honda Civic type-R FN2 2.0 201 KM P2646
Replies: 5
Views: 3225

Re: Honda Civic type-R FN2 2.0 201 KM P2646

Check this out https://www.700r4transmissionhq.com/p2646-honda-civic/ Stock map is made as close to stock as possible ,it's not actually the stock map, as far as I know. I've run a "pop and bangs map" successfully without issues. However this was just a few hours before it became annoying....
by curtusz
Sat Jul 17, 2021 5:11 am
Forum: FlashPro Manager
Topic: Can someone from Hondata speak to this?
Replies: 7
Views: 1759

Re: Can someone from Hondata speak to this?

Some well respected tuners may get a lucrative offer to peddle another product, They won't want you to buy Hondata as its not as financially beneficial for them. Hondata is mostly for the bottom end user ,car enthusiast/DIY if you will ,type of customer. Low cost in comparison for the likes of stand...
by curtusz
Sat Jan 23, 2021 9:31 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Tunning help
Replies: 6
Views: 3348

Re: Tunning help

If u can find a flat straight road .. virtual dyno can see differences on cam angles and ignition advance
by curtusz
Fri Dec 04, 2020 4:22 pm
Forum: FlashPro Manager
Topic: increese motor power
Replies: 6
Views: 2852

Re: increese motor power

<t>You would need to post up a wide open throttle from low rpm all the way to redline datalog and your current calibration.<br/> <br/> Somebody may help you, (I would but I've never messed with k20c)<br/> <br/> <br/> finding the right cam angles, advancing the ignition timing and adding boost would ...
by curtusz
Fri Dec 04, 2020 10:26 am
Forum: FlashPro Manager
Topic: increese motor power
Replies: 6
Views: 2852

Re: increese motor power

In any scenario you would need to wait. 1.to get out of the country to find a tuner 2. Find someone who can street tune your motor. 3 teach yourself (although this would better on a naturally aspirated motor as it is more forgiving with mistakes) Please try not to be impatient tuning on a forced ind...
by curtusz
Fri Jul 24, 2020 6:10 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Speed
Replies: 4
Views: 6980

Re: Speed

If u have matched it to gps speed be careful of speed camera dash speed is usually a few miles higher than actual for this factor
by curtusz
Sat Jun 27, 2020 12:52 pm
Forum: FlashPro Manager
Topic: Flashpro reset
Replies: 1
Views: 4858

Re: Flashpro reset

Just start a new basemap and upload it to ecu
by curtusz
Sat Feb 29, 2020 8:34 am
Forum: Civic Type R 2007-2011 European FN2
Topic: newbie advice please
Replies: 4
Views: 6774

Re: newbie advice please

Cold start would be rich anyway, you can set up the flashpro and check air fuel with rev counter.
by curtusz
Wed Dec 04, 2019 12:07 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Help regarding euro fn2 flashpro
Replies: 2
Views: 5986

Re: Help regarding euro fn2 flashpro

A couple of knocks is nothing mate could be low quality fuel .. set up your ecu to flash when knock occurs ...low ron fuel or/and lugging the engine (eg 6th low rpm foot flat) can cause knock
by curtusz
Thu Nov 28, 2019 5:54 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Lambda very lean at WOT!
Replies: 6
Views: 9088

Re: Lambda very lean at WOT!

No datalog but I was getting 16af on wot changed oring seals and reuploded kal (as ECU was trying to learn with bad seals)
by curtusz
Wed Nov 20, 2019 3:36 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Lambda very lean at WOT!
Replies: 6
Views: 9088

Re: Lambda very lean at WOT!

Could be injector oring seals, happened to mine (not supercharged)
by curtusz
Tue Aug 20, 2019 10:23 am
Forum: K-Pro / KManager
Topic: Best wideband for kpro4
Replies: 16
Views: 8808

Re: Best wideband for kpro4

Yeah that sounds correct they will both need a signal from the lambda not sure which way round on voltage (not sure why it matters) , there will more than likely be an offset that will need to be calibrated (Just try and calibrate it to same as gauge) and you will need to use the smoothing to slow t...
by curtusz
Fri Aug 16, 2019 3:29 pm
Forum: K-Pro / KManager
Topic: Best wideband for kpro4
Replies: 16
Views: 8808

Re: Best wideband for kpro4

Check through this post i made a diy its old so i dont know how relevent it is now

viewtopic.php?f=12&t=18380&start=15
by curtusz
Wed May 15, 2019 9:44 am
Forum: FlashPro Manager
Topic: Cam ignition table help please
Replies: 7
Views: 2234

Re: Cam ignition table help please

You can do it that way. You don't exactly need to tune it .. but what if your vtec solenoid stops working and car doesnt go in to high cam. And you lean out bad ? Its just a fail safe to tune as much as you can